My endy from below also luan kan. So late liao still open glass cover to disturb them.:p:p

Tio lah lah , cannot measure from the side cause if got oyama cannot see !

U dun actually have to open the top cover also .... glass cover is transparent and can measure overlapping if u know wat i mean .

Ok. I will bring your dimensions to go cut tomorrow. Should be correct based on what I've counter measured earlier. I will tell them to split the entire thing into half so that I can place them in. :D

Put in must got skill also hoh .

First lower the pc without EOS halfway only and use a long pvc pipe or those mr aqua ohf long piping . ( Inverted broom also can lah :p:D )

Hold half the acrylic and slowly lay down once u get it to sit in between ur bracing , then slowly use the hard piping to push to the end first .

The again do the same for the eos part , leave some gap for the EOS part so next time can remove easily . ;)

(* My dimension already got gap allowance so dun go and minus further )

Don't understand. Wahahahhahaha.......

Laying should be ok la. Should not be that hard. If keep fish so long lay acrylic also cannot then die Liao. :D

Tomorrow the toa payoh shop open? Any idea?

When u lay not too fast also , ur fish will get stress from the new white acrylic . Try buy the matt white type .

Toa payoh ?? Dama at UBI leh .... sat go long queue ah !!! I go weekdays , half and hour , slant cut also gao tim liao . If all straight cut lagi fast .

Ok I get the Matt type. Long queue? So many ppl doing acrylic on sats ar?:(

The tpy is cut tiles one. Solly, got mixed up.:o

Bro u are lucky , i got something easy to measure and comfirm ur measurement . Pm me ur no .

Supplier from all chain .... I also see ppl custom made those 4 to 5 footer big denitrator or protein skimmer there also . All those reefers favourite DIY place .

Good lord. I better go early then. Be the first in line. Go early finish early.