ph-203 Digital PH/ORP Controller
1 Attachment(s)
Try setting up today morning.
After some help from Bro Alex,finally setup the unit. |
1 Attachment(s)
The controller was plastic seal and it come with a standard 3 pins plug and 3 pins control outlet.
|
PH/ORP controller
Are you using it for ozone generator? use only the ORP controller part?
|
1 Attachment(s)
The set come with 2 probes.One for PH and one for ORP
Both probes are also seal with plastics. Below is thepicture ofone of the probes. |
1 Attachment(s)
After removing the plastics seal from the probe you have to remove the front protection cap also.
This is the front protection cap you need to remove |
1 Attachment(s)
After cleaning the probe under tap water.I connect up to the controller.
I select ORP and M. The initial reading on power up is 154. This reading continue to drop slowly 1 at a time. After about 10 min it is reading 131. |
Quote:
Thank You Regards |
Quote:
Question: How long it take for the controller to stablise, I got funny reading, everytime I turn on the ozone generator, the reading start droppping (thought its suppose to increase).Clueless??? :confused: |
Ariel .. check out this thread as there are discussions regarding how long does the orp probe stabilize.
http://www.arofanatics.com/forums/sh...8&page=1&pp=10 |
Just take a look at the PH/ORP controller.The reading now is 198.
Please note that I have not connect up my ozone generator yet. Regards |
All times are GMT +9. The time now is 03:38 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright © 2000-2008 Arofanatics.com (Since 30th August 2000)