Quote:
Originally Posted by cheetf
Bro no need whole probe into the tank. The exposed part will do.
|
If put too high up the temp will different by alot due to the lighing.
Quote:
Originally Posted by SaDan
Bro koji.. Tot read somewhere more accurate when place near the inlet..? Correct mi if I wrong.. Heh
|
Actually the read should be taken either mid of tank or bottom of tank more accurate and will reduce cut in and cut out alot
Quote:
Originally Posted by cheetf
Actually got a bit of a concern. If the black part is not sealed properly you have just connected a very long hose which can carry water right into your chiller electrical components.
|
How is the water going to get carry back to the chiller bro no hard feeling? The black rubber is heat shrink to cover the cable that is solder to the thermostate. As for the grey colour is the rubber insulation not acting at a hose it is rubber insulation to protect the i think is cat 5 cable from damage. Even if water get in at the black heat shrink it will short the thermostate contact with the wiring but will never bring water back down to the chiller.