Quote:
Originally Posted by Vitor
I did for my 522. using 4ft PP boards at bras bersah art friend, cheap and good.
1 whole pic is not able to cover fully and wont go in because of bracing at centre.
so i bought and cut the PP boards to slightly less 2 ft to fit into the height of the tank. total i bought 3 pcs all cut to 2ft less a bit for height(or above the water level)
measure the width , slightly less than 2 ft.
i will cut the outer layer only so to easy to bent on the inner layer.
bent already will be 2 ft less so u can insert into tank.
then put both left and right side. so will be a gap at centre.
then the centre cut the 3rd pp board to 4" longer than gap measured.
then fill the gap at the centre with 2" each side overlapping.
i use suction cups to hold. every corner.
8 cups on both sides. the center pc is held by the 2 side boards pressed.
so far no issue for the 7mths i used. and later thrown away.
better and not shiny so no reflection.
|
sorry correction i use 8 suction cups on one side. 4 corners of each face.
so 16 suction cups. total.
hold use a screw driver heat up and melt thru. as long as ur suction cup eyelid can squeeze thru , its good.