|
05-03-2005, 07:13 PM | #1 |
Guest
Posts: n/a
|
Setting a Co2 Cylinder system...
Is there anything to specifically set for this system? I got the solenoid, regulator, diffuser, reactor, bubble counter. Do I just plug it in and thats it?
|
05-03-2005, 08:45 PM | #2 | |
Guest
Posts: n/a
|
Quote:
Thats my newbie method |
|
05-03-2005, 08:54 PM | #3 |
Guest
Posts: n/a
|
I reckon the whole thing was being setup at the shop already?
If so, plug in into the power supply. Turn the main valve on top to the full. Slowly adjust the small knob at the side for the number of bubbles you want (you can see from the bubble counter). Set the CO2 rate till you get the desired one.This will be your CO2 rate permanently (thats the advantage of having a solenoid) till you readjust the knob again if you are not happy with the rate in future Measure CO2 levels through the kh/ph chart |
06-03-2005, 03:11 PM | #4 | |
Guest
Posts: n/a
|
Quote:
1. Turn the main valve all the way to pressurise the regulator. 2. Turn off the main valve. 3. Wait a day and make sure the pressure reading by the regulator did not drop. If ok, 1. Open main valve. 2. Plug solenoid into power/timer 3. Adjust bubble rate to desire count. Jack |
|
06-03-2005, 11:31 PM | #5 |
Arofanatic
Join Date: Aug 2004
Posts: 331
|
Need to put a check valve before the bubble counter.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|