|
|
27-02-2017, 08:23 PM | #1 |
Senior Dragon
Join Date: Mar 2002
Posts: 3,495
|
cannister filter problem
I just switch a canister filter previously for a 200L tank to a 70L tank. The filter will tend to give out rattling sound after operating for 1-2 hours. This seems to be due to the impeller working with less than optimal water level in the canister. At first I thought because I have placed the canister too high on a chair. But after I place it on the floor, the same problem persist. The impeller had just been replaced with a new one when I re operated it.
Could it be anything to do with the level of the inlet and outlet points in the tank, length of the hose or water level/tank volume, can anyone experienced with canister advice me? |
28-02-2017, 12:02 PM | #2 |
Arofanatic
Join Date: Jul 2005
Posts: 239
|
maybe the shaft was not inserted properly...
|
28-02-2017, 01:29 PM | #3 |
Senior Dragon
Join Date: Mar 2002
Posts: 3,495
|
|
28-02-2017, 02:55 PM | #4 |
Dragon
Join Date: Jul 2006
Posts: 1,561
|
You capped the impellor properly? The new bought impellor is original or cheong one? Do note the shaft length and wings length does matter. Anyway you can try back the old one?
|
28-02-2017, 04:06 PM | #5 |
Senior Dragon
Join Date: Mar 2002
Posts: 3,495
|
Original. I bought from local distributor. It is a fluval. I suspect the hose are too long, I am waiting for more opinions before I decide if I should cut them to just nice length.
|
28-02-2017, 04:48 PM | #6 |
Arofanatic
Join Date: Feb 2017
Posts: 64
|
i have total of 4 canister, not fluval though, but Ejet.
I have 3 that run the full length, lazy to cut the hose and 1 that running at very short length. 2 x canister on right side and same height, placed about 1m away from the tank. 1 for top tank and 1 for bottom tank. 2 x canister next to left of tank, of which 1 x canister is for top tank and 1 x canister is just beside the bottom tank canister on a slightly raised floor. Is a 2 tier stand so bottom tank height is about slightly more than 2 ft and top tank height at highest point is about 6ft no such issue on all 4 canister. super quiet. just curious, when you change the impeller, does it include the magnet? Maybe magnet not strong enough to hold impeller |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|