Just My Shrimp Thread

Originally Posted by Koji™

Thank you breeder Because my water cold cold?

yah.. i think cause your water colder then mine! zzzz!!!
how can like that! pass back to me!

[saddyboi]

Originally Posted by Koji™

A close up of my DIY air stone. Basically it's the nozzel from DYMAX powerhead you buy and the base is the small small pot from those water plant you buy from LFS.

looks so cute.. haha... but the bubble seems to have a very big impact.. haha..

Originally Posted by Koji™

Cannot just keep water, moss and snails meh?

can can you decide mah, throw in CRS to do selective breeding?

Originally Posted by Koji™

Thank you breeder Because my water cold cold?

my snow white, all crack crack de

Originally Posted by thxpro98

my snow white, all crack crack de

wait for bro koji to breed then he will let some go to you liao!

Originally Posted by berber

wait for bro koji to breed then he will let some go to you liao!

so kind? should i cross-breed snow white with CRS mah?, i transfer all the snow white to my lone tank, wondering should transfer back mah..

[Koji™]

Originally Posted by berber

yah.. i think cause your water colder then mine! zzzz!!!
how can like that! pass back to me!

Later go back colour drop how?

Originally Posted by thxpro98

so kind? should i cross-breed snow white with CRS mah?, i transfer all the snow white to my lone tank, wondering should transfer back mah..

for me i dont mix them together.. i dont want more snowwhite from my crs! trying to clear the gene! haha

Originally Posted by Koji™

Later go back colour drop how?

haiz... then nvm lorh! pass you back!

Originally Posted by berber

for me i dont mix them together.. i dont want more snowwhite from my crs! trying to clear the gene! haha

ohh, ya true i notice snow whites from my CRS, no point producing crack crack de snow white

Originally Posted by cheetf

Bro no need whole probe into the tank. The exposed part will do.

If put too high up the temp will different by alot due to the lighing.

Originally Posted by SaDan

Bro koji.. Tot read somewhere more accurate when place near the inlet..? Correct mi if I wrong.. Heh

Actually the read should be taken either mid of tank or bottom of tank more accurate and will reduce cut in and cut out alot

Originally Posted by cheetf

Actually got a bit of a concern. If the black part is not sealed properly you have just connected a very long hose which can carry water right into your chiller electrical components.

How is the water going to get carry back to the chiller bro no hard feeling? The black rubber is heat shrink to cover the cable that is solder to the thermostate. As for the grey colour is the rubber insulation not acting at a hose it is rubber insulation to protect the i think is cat 5 cable from damage. Even if water get in at the black heat shrink it will short the thermostate contact with the wiring but will never bring water back down to the chiller.

hot rises and cold sink, so normally coldest water is at the bottom. Power la bro avex30, become sci teacher liao. hee hee