Gill Curl

Does anyone know how to operate gill curl?


Sent from my iPhone using Tapatalk

[Aro77]

Hi bro belive there are few threads on this already u may wana search hope this helps btw if its just a slight curl at the tip u may wana consider doing it your self Cheers

[Homester]

What is the cause of the gill curve ? And how bad isit ?

Originally Posted by Homester

What is the cause of the gill curve ? And how bad isit ?

bro, its probably caused by water quality as it was fussy over mp and i think some leftovers polluted the water
one side seems permanent while the other side just started to curve

[sbtanpatrick]

http://www.arofanatics.com/forums/sh...ight=gill+curl

Bro u can refer to the above link......

I have done it myself on my rtg previously ...easy....use transmore n small scissor n trim nicely...

[streetsmart73]

Ts,the main contributor to curl gills is water parameters.

what's your wc regime?

[sbtanpatrick]

Originally Posted by macho_threz10

I have done it myself on my rtg previously ...easy....use transmore n small scissor n trim nicely...

When using transmore must be careful with the dosage......

Originally Posted by streetsmart73

Ts,the main contributor to curl gills is water parameters.

what's your wc regime?

I started with weekly change, about 5% with salt and conditioner. But I think the problem started when I switched from baby frogs diet to mp… as the are spitted out some of the meat and i didn't clear it immediately…

i'm now doing water change about 2-3 times per week… hoping to get the quality back to normal

[sbtanpatrick]

Originally Posted by karwes

I started with weekly change, about 5% with salt and conditioner. But I think the problem started when I switched from baby frogs diet to mp… as the are spitted out some of the meat and i didn't clear it immediately…

i'm now doing water change about 2-3 times per week… hoping to get the quality back to normal

5% WC is too little bro....u need to change at least 30% or more.....do not add salt unless u are doing treatment....